Injection Molding DFM Checklist
Use this list to prepare a file. It does not replace a review of your actual geometry.
Geometry
Keep walls as uniform as the design allows. For typical injection molding wall thickness ranges by resin, transitions, ribs and cycle-time notes, see our wall thickness guidelines. Add draft on surfaces that release, more where texture is deep—see draft angle in injection molding for typical starting ranges and texture rules. Call out undercuts so slides are a decision, not a surprise.
Cosmetics
Mark the primary view. Gates and ejectors should not land there unless you accept the witness. Weld lines follow flow; move them in DFM, not after texture. For how sink, flash, short shots and related injection molding defects show up—and what to fix in CAD versus at trial—see our molding defects guide.
Data
One released revision, a resin, and a note on which tolerances are functional. A title block full of general tolerances is not a control plan.